This package contains eight swing gates in two different lengths. Four are a scale 15' long while the other four are 21 scale feet in length. Four of the gates also have a blunt tip while the other four have a pointed end. To mount on a layout or module:

1. Paint the gates a metallic color such as silver or aluminum and then remove them from the border.

2. If signs are also desired, paint them a red or yellow color on the front and a metallic color on the rear. Once dry remove them from the border and glue them to the vertical bar within the gate using cynacrolite.

3. Using a small flat head screwdriver or drill, press small holes in the desired locations and glue the gate into place using a suitable adhesive such as Elmer's Glue.

There is a gap at the end of each gate. This gap is normally not on the prototype however we wanted to allow the modeler to have the gate open or closed. If this gap is not desired simply bend the bar over so that it is flush with the tip of the gate and glue it. Next cut of the any excess material to have a flush look